Re: Gigablue Quad 4K a Wifi dongle s MT7601u ?

[mackh]

Funguje nekomu tato kombinace ?
Zkusil jsem ovladac verze r0 a r2 stazeny z pluginu a r1 stazeny z netu a s zadnym prijimac USB adapter nevidi.

[9000peter]

Ak sú to tie dva prijímače čo máš v podpis s ATV 6.4 ktoré je už EOL tak by som skúsil prejsť na minimálne openatv 7.3 či nieje tam pes zakopaný

[gchevalier]

v tom ipk je len odkaz na ine baliky

Kód: Vybrat vše

Recommends: firmware-mt7601u, mt7601u

v principe je potrebne doinstalovat

Kód: Vybrat vše

kernel-module-mt7610u, firmware-mt7601u

[9000peter]

Ale písal že sťahoval aj z feedu kde mu to tiež nefunguje.
Crenshot z feedu openatv 7.4
mackh a len tak mimochodom čo je to zač to "USB adapter"

[mackh]

Je to Octagon WL048

P.S.
OpenATV 7.x nemohu pouzivat, protoze tento FW neumi vyvolat seznam kanalu tlacitkem OK

[kratke_pole]

A nieco podobne ako v prilohe najdes ?
je to z ATV 7.3

[mackh]

Najdu, ale s HD Glass 17 to muzes menit jak chces, ale nefuguje to.

[matko33]

Zasrtc do usb a v terminale daj command dmesg, potom hladaj kde je problem co mu chyba
Pokial nie je mrtvy nieco tam najdes
Mozno budes musiet natiahnut nejake .so kniznice cez modprobe

[mackh]

root@gbquad4k:~# dmesg | grep USB
[ 1.298875] xhci-brcm f0471000.xhci_v2: new USB bus registered, assigned bus number 1
[ 1.322502] hub 1-0:1.0: USB hub found
[ 1.339321] xhci-brcm f0471000.xhci_v2: new USB bus registered, assigned bus number 2
[ 1.355677] hub 2-0:1.0: USB hub found
[ 1.373578] ehci-brcm f0470300.ehci_v2: new USB bus registered, assigned bus number 3
[ 1.403607] ehci-brcm f0470300.ehci_v2: USB 2.0 started, EHCI 1.00
[ 1.410186] hub 3-0:1.0: USB hub found
[ 1.423909] ehci-brcm f0470500.ehci_v2: new USB bus registered, assigned bus number 4
[ 1.453609] ehci-brcm f0470500.ehci_v2: USB 2.0 started, EHCI 1.00
[ 1.460176] hub 4-0:1.0: USB hub found
[ 1.477960] ohci-brcm f0470400.ohci_v2: new USB bus registered, assigned bus number 5
[ 1.547006] hub 5-0:1.0: USB hub found
[ 1.568636] ohci-brcm f0470600.ohci_v2: new USB bus registered, assigned bus number 6
[ 1.623015] hub 6-0:1.0: USB hub found
[ 1.682639] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 1.693716] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[ 1.694735] usb 2-2: new SuperSpeed USB device number 2 using xhci-brcm
[ 1.709890] hub 2-2:1.0: USB hub found
[ 1.790609] usb 4-1: new high-speed USB device number 2 using ehci-brcm
[ 1.908026] hub 4-1:1.0: USB hub found
[ 1.932710] usbhid: USB HID core driver
root@gbquad4k:~#

[EnoSat]

najskor lsusb

[mackh]

root@gbquad4k:~# lsusb
Bus 002 Device 002: ID 05e3:0620
Bus 004 Device 002: ID 05e3:0610
Bus 001 Device 001: ID 1d6b:0002
Bus 002 Device 001: ID 1d6b:0003
Bus 003 Device 001: ID 1d6b:0002
Bus 004 Device 001: ID 1d6b:0002
Bus 005 Device 001: ID 1d6b:0001
Bus 006 Device 001: ID 1d6b:0001
Bus 004 Device 003: ID 148f:7601
root@gbquad4k:~# dmesg | grep usb
[ 0.047659] usbcore: registered new interface driver usbfs
[ 0.047692] usbcore: registered new interface driver hub
[ 0.047729] usbcore: registered new device driver usb
[ 1.334128] usb usb2: We don't know the algorithms for LPM for this host, disabling LPM.
[ 1.620306] usbcore: registered new interface driver usb-storage
[ 1.676942] usb 2-2: new SuperSpeed USB device number 2 using xhci-brcm
[ 1.685934] usbcore: registered new interface driver usbhid
[ 1.685936] usbhid: USB HID core driver
[ 1.776527] usb 4-1: new high-speed USB device number 2 using ehci-brcm
[ 35.179198] usbcore: registered new interface driver btusb
[ 934.178797] usb 4-1.3: new high-speed USB device number 3 using ehci-brcm
[ 934.351664] rtusb init rt2870 --->
[ 934.405028] usbcore: registered new interface driver rt2870
root@gbquad4k:~#

[matko33]

Ak sa nepohnes dalej, skusil by som nepriamu metodu,
Napr pri openwrt najst dependancies na tie xhci a ehci.....

Maju to pekne spracovane

Ak tam mas este starsi syste, ifconfig co pise?

[mackh]

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:323 (323.0 B) TX bytes:323 (323.0 B)

[EnoSat]

a pozri si od ktoreho kernelu je v linuxe podporovane 7601
ale pre Quad to vypada naprd

[matko33]

A ked rozbalis ten ipk, je v nom .so driver?
Ak ano, skusil by som ho natiahnut cez modprobe a pozrel do dmesg kde je problem

A ako pise aj sevalier, ved v tom ipk nic nie je!?

[mackh]

4.2
dik za info

[matko33]

Potom zostava uz iba najst driver pre linux source kod a urobit si preklad

Napr:
https://github.com/flexiti/mt7601

[mackh]

Tak to uz je nad moje znalosti ....

[matko33]

Vsetko je prvy krat, zisti si verziu kernelu "uname - r" a skus najst daky rasbpian s rovnakou verziou

Potom je to uz brnkacka

[mackh]

je to verze 4.1.20-1.9

raspbian jsem ale nasel jen 5.1